Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

On This Page

Table of Contents
minLevel1
maxLevel7

...

Use this field to specify a start time for the first scan in the schedule.  If a time is not specified, the first scan will start after midnight. Specify the time using the format HH:MM XM.

Last scan

...

start time

Use this field to specify the time you want the last job run to start.  If a time is not specified, the last job run will start no later than midnight. Specify the time using the format HH:MM XM.

Note that a scheduled job will not run if the last run time for the job equals the “Last run start time” set in the job schedule. For example, if you schedule a job to run every 15 minutes starting at 1:00 PM and ending at 1:30 PM, the job will run at 1:00 PM and then at the scheduled 15-minute increment. If the next run time calculated for the job is 1:30 PM (the same as the “Last run start time” set for the job), 1:30 PM will show as the “Next run” time in the UI for the job, but the job will not be run again at 1:30 PM.

Maximum number of daily source scans

...